Were you fit for this club?

Good question, I am not aware of any shafts that advertise specifically their fade or draw bias....that is more of a function of other factors primarily.  However, the stiffness (too weak or stiff) could impact this factor without question relative to your swing type...just my two cents...I just met Cathi and Cameron in person last week and they are extremely knowledgeable about these things so I will leave the final call up to them!

I wasn't fitted but I can get on a launch monitor. I should have said that the flex is stiff and the head was set to B1.

The 910 head has the option to adjust loft that will also open (decrease loft) and close the face (increasee loft) to adust fade or draw.  Shafts ordinarily adjust for spray - too soft will be hard to control with shaft flex/torque and too stiff may not get enough loft for full carry.  If your flex is too soft for your tempo, it may be snapping shut and promoting draws/hooks.

After you get the right shaft for your swing, then you can adjust your setup and swing path to promote fades and draws with more consistency.  I prefer to think of it as correcting a draw more than generating a fade bias.  I recently switched to the S+ to correct both a fade that also dropped straight down with no roll.  I had too much backspin based on a monitor.

i have not heard of shafts promoting this ball flight, but if your looking for certain ball flights easiest way ive found to work the ball is in the simplest way of alignment ex. slight open stance with the face of the driver pointed at my target swinging across the path promoting a fade. just a little advice slightly stiffer shaft will make it harder to get these results though.